Finisar FTLF8528P2BNV Datasheet Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
FTLF8528P2BNV Pluggable SFP+ Product Specification – November 2007
© Finisar Corporation November 21, 2007 Rev. B Page 4
III. Electrical Characteristics (T
A
= -5 to 85 °C, V
CC
= 3.0 to 3.6 Volts)
Parameter Symbol Min Typ Max Unit Ref.
Supply Voltage Vcc 3.0 3.6 V
Supply Current Icc 240 mA
Transmitter
Input differential impedance R
in
100
Ω
1
Single ended data input swing Vin,pp
90 800 mV
Transmit Disable Voltage V
D
2 Vcc V 2
Transmit Enable Voltage V
EN
Vee Vee+ 0.8 V
Receiver
Single ended data output swing Vout,pp
170 400 mV 3
Data Output Rise/Fall Time @ 2.125, 4.25 Gb/s t
r
/ t
f
120 ps 4
Data Output Rise/Fall Time @ 8.5 Gb/s t
r
/ t
f
60 ps 4
LOS Fault V
LOS fault
2 Vcc
HOST
V 5
LOS Normal V
LOS norm
Vee Vee+0.8 V 5
Power Supply Rejection PSR
100 mVpp 6
Deterministic Jitter Contribution @ 2.125 Gb/s
RX
Δ
DJ
47.1 ps
Total Jitter Contribution @ 2.125 Gb/s
RX
Δ
TJ
123.5 ps 7
Deterministic Jitter Contribution @ 4.25 Gb/s
RX
Δ
DJ
23.5 ps
Total Jitter Contribution @ 4.25 Gb/s
RX
Δ
TJ
61.8 ps 8
Deterministic Jitter @ 8.5 Gb/s RX DJ 49.4 ps 8
Pulse Width Shrinkage @ 8.5 Gb/s RX
DDPWS
42.4 ps 8
Total Jitter @ 8.5 Gb/s RX TJ 83.5 ps 8
Notes
:
1. Connected directly to TX data input pins. AC coupling from pins into laser driver IC.
2. Or open circuit.
3. Into 100 ohms differential termination.
4. Unfiltered, 20 – 80 %
5. LOS is an open collector output. Should be pulled up with 4.7k – 10kohms on the host board. Normal
operation is logic 0; loss of signal is logic 1. Maximum pull-up voltage is 5.5V.
6. Receiver sensitivity is compliant with power supply sinusoidal modulation of 20 Hz to 1.5 MHz up to
specified value applied through the recommended power supply filtering network.
7. If measured with TJ-free data input signal. In actual application, output TJ will be given by:
()()
22
DJTJDJTJDJDJTJ
INININOUT
ΔΔ++Δ+=
8. As defined in FC-PI-4
1
, Rev 7.0, Table 13, 800-Mx-SN-y.
Page view 3
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments